496256 Issue 1
9
If you do not close the final door before the end of the exit time then the
system gives an internal alarm and
does not set.
Go back to the keypad and
unset the system, see "3. After an Alarm".
Note:
Some Levels on your system may be programmed for
Silent Set
. When
setting these Levels the system does not give any tones from the keypads.
Final Door
With Final Door setting the system sets seven seconds after you close the
last door.
1.
Close all doors and windows.
2.
Key in your access code at the keypad.
3.
Press the appropriate Level button followed by Enter.
The keypad starts the continuous exit tone, the
Level LED flashes, and the display shows:
AREA READY
LEAVE
4.
Leave via the designated exit route and close the final door.
The system sets and stops the entry/exit tone seven seconds after you
close the final door.
Exit Terminate Button
In Exit Terminate Button setting the system completes setting after you press
a button mounted outside the premises by the final door.
1.
Close all doors and windows.
2.
Key in your access code at the keypad.
3.
Press the appropriate Level button followed by Enter.
The keypad starts the continuous exit tone, the
Level LED flashes, and the display shows:
AREA READY
LEAVE
4.
Leave via the designated exit route. Close the final door.
5.
Press the exit terminate button.
The exit tone stops and after seven seconds the system sets.
Note:
The Installer may have programmed your system to set after a fixed time even
if you do not press the exit terminate button. This is to make sure your
premises are protected even if you forget to press the exit terminate button.
Ask your Installer how your system is set up.
Instant Set
With Instant Setting the system sets as soon as you complete entering the
set command from the keypad.
2. Everyday Operation
