496256 Issue 1
11
A fault message means that one of the detectors is being triggered (for
example, a door or window is open).
The system will not set until you
have cleared all the faults.
A trouble message means that one of the detectors may be reporting that it
has a technical problem. The system can still set when there is a trouble
message, but you should report the message to you Installer.
For both types of message the keypad display can show you which zones
have problems.
For faults the displays shows (for example):
SETTING STOPPED
02 FAULTS EXIST
The system cannot finish setting because two detectors are being
triggered.
1.
Press the A or B keys.
The display shows each zone that is being triggered.
2.
Press A or B repeatedly until you have seen all the faults. Note down the
zones reported.
3.
Go to each zone and find out what is triggering the detector. If possible
remedy the fault.
4.
Go back to the keypad, press Menu, and try to set the system again.
For trouble messages the displays shows
(for example)
ZONES IN TROUBLE
1 FAULT
The system can still set.
1.
Press the A or B keys.
The display shows the zone that is reporting trouble.
2.
Press A or B repeatedly until you have seen all the trouble messages.
Note down the zones reported.
3.
Press Enter.
The display shows:
AREA READY
LEAVE
4.
Leave via the designated exit route. Close the final door.
Zones giving trouble reports do not affect the system security.
Your alarm system will still work correctly. Contact your alarm
company to let them check the system.
2. Everyday Operation
