18
496256 Issue 1
To reinstate a 24 hour zone: repeat steps 1 to 6
but
at step 5 press C or D to
make sure the display shows "UN-OMITTED".
Turning the Chime On/Off (Menu 3)
Your system may be programmed so that a chime tone sounds whenever
certain doors are opened. If you want to turn this feature on or off:
1.
Key in your access code and press
Menu
followed by
3
.
The display shows:
3: SYSTEM OPTIONS.
2.
Press Enter.
The system displays the current state of the
chime function:
CHIME
DISABLED
3.
Press A or B to change between "DISABLED" and "ENABLED".
The display shows:
CHIME
ENABLED
4.
Press Enter to save the change and to go on to change the internal
sounder volume. Otherwise press Menu twice to go back to the time
and date display.
Changing the Volume of the Internal Sounder
If your internal sounder is too loud or quiet, you can change its volume from
the keypad.
1.
Key in your access code and press
Menu
followed by
3
.
The display shows:
3: SYSTEM OPTIONS.
2.
Press Enter twice.
The display shows:
SOUNDER VOLUME
V. HIGH
3.
Press A or B to change the volume of the internal sounder. There is a
choice of "V. HIGH", "HIGH", "MEDIUM", "LOW" and "V. LOW".
4.
Press Enter to save the change and to go on to test the system. Other-
wise press Menu twice to go back to the time and date display.
Testing the System (Menu 4)
You can set the system so that it will allow you to walk round the premises
and test each of the detectors (a
walk test
). At the same time you can also
test the external bell and strobe. Choose a time when the premises are
empty to carry out the test, otherwise people may trigger any movement
detectors before you do, and confuse the results of the test.
4. Special Functions
