Scanlab RTC 5 PC Interface Board, Installation And Operation Manual

Page: 563 / 622

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
563
innovators for industry
Ctrl Command select_list
Support status This RTC
®
2/RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4

RTC
®
5 select_list (0) can be replaced by set_extstartpos (0), select_list (1) by
set_extstartpos (
Mem1
). Thereby,
Mem1
is the memory size of “List 1” (and the absolute start
address of “List 2”). After initialization (with load_program_file ),
Mem1
is 4000, otherwise
as set via config_list .
Mem1
can be determined (e.g. after a board changed “ownership”)
via set_start_list_2 and get_input_pointer .
Ctrl Command set_base
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by There is no equivalent command for the RTC
®
5 (because it is a plug-and-play board
whose base address is automatically set).
Ctrl Command set_co2_standby
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_standby (see page 488)
List Command set_co2_standby_list
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_standby_list (see page 489)
List Command set_delays
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_laser_delays (page 442) , set_scanner_delays (page 475)
List Command set_encoder_values
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_fly_x (page 429) , set_fly_y (page 431)
Ctrl Command set_gain
Support status This RTC
®
2 command is not supported by the RTC
®
5.
Replaced by set_matrix (page 449) , set_offset (page 463)
Ctrl Command set_list_mode
Support status This RTC
®
3/RTC
®
4 command is not supported by the RTC
®
5.
RTC
®
4

RTC
®
5 See "Circular Queue Mode", page 82 .