Chapter 5 Configuring
T H E P M 1 3 0 P L U S
General
M E T E R S E T U P
PM130 PLUS Powermeter Series
81
Configuring Relay Outputs
The PM130 PLUS can be provided with two optional relay outputs. Each
relay can be operated either locally from the alarm/control setpoints in
response to an event or by a remote command sent through
communications. It can also be linked to an internal pulse source to
produce energy pulses.
Using the Front Display
Select reL from the main menu. This menu entry appears only if the digital
I/O module is plugged into the meter.
Use the
UP
and
DOWN
arrow buttons to scroll to the required relay.
To select a relay parameter:
1.
Press the
SELECT
button to activate the middle window.
2.
Use the
UP
and
DOWN
arrow buttons to scroll to the required
parameter.
To change the parameter value:
3.
Press the
SELECT
button to activate the lower window.
4.
Use the
UP
and
DOWN
arrow buttons to select the required value.
5.
Press
ENTER
to confirm the new parameter setting or press
ESC
to
discard changes.
6.
You are returned to the middle window and can configure other relay
parameters.
To store your new settings:
1.
Press the
ENTER
button when the middle window is highlighted.
2.
You are returned to the upper window and can select another relay
output or exit the menu.
3.
Press
ESC
to exit the menu.
See Table 23
for the available relay outputs options.
Using PAS
Select
General Setup
from the
Meter Setup
menu, and then click on the
Relay Outputs
tab.
