2
PM130 PLUS Powermeter Series
LIMITED WARRANTY
The manufacturer offers the customer a 24-month functional warranty on the instrument for faulty
workmanship or parts from date of dispatch from the distributor. In all cases, this warranty is valid
for 36 months from the date of production. This warranty is on a return to factory basis.
The manufacturer does not accept liability for any damage caused by instrument malfunction. The
manufacturer accepts no responsibility for the suitability of the instrument to the application for
which it was purchased.
Failure to install, set up or operate the instrument according to the instructions herein will void the
warranty.
Only a duly authorized representative of the manufacturer may open your instrument. The unit
should only be opened in a fully anti-static environment. Failure to do so may damage the
electronic components and will void the warranty.
The greatest care has been taken to manufacture and calibrate your instrument. However, these
instructions do not cover all possible contingencies that may arise during installation, operation or
maintenance, and all details and variations of this equipment are not covered by these instructions.
For additional information regarding installation, operation or maintenance of this instrument,
contact the manufacturer or your local representative or distributor.
WARNING
Read the instructions in this manual before performing installation and take note of the following
precautions:
Ensure that all incoming AC power and other power sources are turned OFF
before performing any work on the instrument. Protect the measurement AC
Inputs voltage (V1, V2, V3) with 2A external overcurrent protection device
and the power supply source inputs with 5A external overcurrent protection
device, located close to the equipment.
Before connecting the instrument to the power source, check the labels on
the back of the instrument to ensure that your instrument is equipped with
the appropriate power supply voltage, input voltages and currents. Failure to
do so may result in serious or even fatal injury and/or equipment damage.
Under no circumstances should the instrument be connected to a power
source if it is damaged.
To prevent potential fire or shock hazard, do not expose the instrument to
rain or moisture.
The secondary of an external current transformer must never be allowed to
be open circuit when the primary is energized. An open circuit can cause
high voltages, possibly resulting in equipment damage, fire and even serious
or fatal injury. Ensure that the current transformer wiring is secured using
an external strain relief to reduce mechanical strain on the screw terminals,
if necessary.
Only qualified personnel familiar with the instrument and its associated
electrical equipment must perform setup procedures.
Do not open the instrument under any circumstances when it is connected
to a power source.
