Sartorius MC 210 S, Installation And Operating Instructions Manual

Page: 24 / 188

Turning the Display On and Off (Standby Mode)
Press the
e
key
(31)
to turn the display on or off.
Self-Test
After the balance has been turned on, an automatic
self-test of the balance’s electronic circuitry
is performed, and the draft shield closes automatically.
When a zero readout is displayed, the balance
is ready for operation.
Automatic Warmup of the Balance Electronics in
MC 210 S, MC 210 P and MC 410 S (-0CE), MC 21 S
Once you have connected the balance to AC power
and turned on the power, the balance’s electronics
automatically begin to warmup. The timer for
warmup is set to 4 minutes. The remaining warmup
time in minutes and seconds is displayed in
a countdown mode.
When the remaining time displayed is less
than one minute, you can interrupt this warmup
procedure by pressing the
e
key to turn the
balance off and back on again. Following
the self-test and display of a zero readout,
the balance is ready to operate again.
After 4 minutes have elapsed, the balance displays
a zero readout and is then ready to operate.
* = including the Signatories of the Agreement on
the European Economic Area
Important Note Concerning Verified Balances
Approved for Use as Legal Measuring Instruments
in the E.U.*
For verified balances that have a verification
scale interval “e” which is greater than the scale
interval “d,” and a scale interval “d”
≥
0.1 mg,
the last digit on the display is bordered.
1–20