Sagem 5890bdn, User Manual

Page: 64 / 176

3-16
Setting your machine
Date en cours : 7 June 2006
C:\Documents and Settings\G092899\Bureau\LU 252 745 055A HFF 5890dn_EN\Configuration Gb.fm
Press the
MENU
key.
Switch your terminal off and then back on again. You have now finished configuring the
IP address.
Manually configuring IP settings
You can make these settings when the TCP/IP protocol is on.
To configure your terminal manually, you will need the usual information for setting up a peripheral
(IP address, subnet mask and gateway address).
To manually configure network local settings:
MENU - - INTERFACE > - - TCP/IP > DHCP
Check that DHCP is set to
OFF
. If not press
OK
, then select
OFF
with the or keys. Press
OK
.
Press .
Press
OK
to enter the IP address. A cursor (_) starts to flash in the right-hand segment (3
figures). Press the key to increment the value and the key to decrement it. Once you have
set the value for the right-hand segment, press the
<
key to place the cursor in the next segment.
Again, press the key to increment the value and the key to decrement it. Proceed in the
same way for all of the segments. Press OK once all the segments have been set up.
Press .
Enter the subnet mask address in the same way as for the IP address.
Press .
Enter the gateway's IP address in the same way as for the IP address.
Press the
MENU
key.
Switch your terminal off and then back on again. You have now finished configuring the
IP address.
Note: Other print-related settings are described in the Print Functions chapter.
R
EMOTE CONFIGURATION
You can configure the same settings either remotely or locally.
System requirements
To remotely configure your machine you will need:
• a Web browser (preferably Internet Explorer version 4),
• to make the Local Network settings for your machine (IP address, subnet mask, etc.). You should
ask your network administrator for these settings. Once you have this information, please see the
paragraph
Local network settings , on page 3-11 on how to fill out the necessary fields.