MAX100/200-OPERATION Rev200813
62
Update Remote Device Firmware (Hardware Components)
The display module can be used to update the firmware of the hardware components over the CAN Bus connection.
Hardware components that can be updated include: injectors, hydraulic controllers, low-flow option and water valve.
The manufacturer will provide an firmware update file when needed. This file should be copied to a USB device into
the "SF"directory (folder), and create the "SF" directory (folder) if it does not exist.
1. On the back of the unit, remove the USB access port cap located next to the wiring connector. Twist the cap
counterclockwise
to open it. Insert the USB device into the USB connector.
2. Select 'FACTORY' on the main menu. Press the
SELECT
button to access the submenu.
3. Select 'FIRMWARE UPDATE. Press the
SELECT
button to access the submenu.
4. Select 'UPDATE REMOTE DEVICE. Press the
SELECT
button to access
the firmware file list.
5. Press the
INCREASE
or
DECREASE
button to select the firmware file
that was copied onto the USB device. Press the
SELECT
button to display
the list of compatible devices.
6. Press the
INCREASE
or
DECREASE
button to select the device to be
updated. Devices are identified by their serial numbers and the current
firmware version. Press the
SELECT
button to start the update process.
When the dialog box appears, press the
SELECT
button to proceed with
the update, or the
ON/OFF
button to cancel the process.
7. Once the update has started, a progress bar will be displayed.
NOTE: Do not disconnect power from the valve controller or the valve.
8. After the firmware update has been completed, a confirmation dialog
box will be displayed. Press the
SELECT
button to return the list of
compatible devices.
9. If any other devices need to be updated, repeat steps 6-8.
10. If no additional updates are needed, remove USB device from the unit and replace the USB access port cap.