Installation and operating manual: NEO/NEO-PS v.1.4S EN
b. Pressing the LOAD FLASH FROM DISC field will activate the file manager window. Point a required file with
update on disc (*flsh) localization, and press OPEN. The file will be loaded and the following information
displayed:
np. the file name for MGSM 4.0/4.0-PS version 1.0 will have the form:
„mgsm-4.0_v1.0.flsh”
2. Press the SAVE CONFIG TO MGSM switch and observe the procedure:
(displayed in the PARTNER GSM software window)
-
switch off the module power supply,
-
press and hold the PR switch in the module,
-
switch on the module power supply,
-
keep the switch pressed until the red FAIL LED starts flashing.
The following message will be displayed: FLASH IN PROGRESS – PLEASE WAIT
The firmware in the module microprocessor system will be replaced.
The replacement progress will be shown with the indicator:
Successfully terminated operation will be signalized with the message:
FLASH TERMINATED SUCCESFULLY.
PRESS THE PR SWITCH TO RESUME COMMUNICATION.
Remarks:
●
If the WRITE SOFTWARE TO MODULE switch is not active, set the appropriate COM in the
bookmark and open the port using the switch
which will change it’s state to:
.
●
As the procedure starts, the following message may be displayed:
Error: BOOT LOADER DID NOT REPLY – REPEAT PROCEDURE. The procedure in point 2
should be repeated, observing the time relations in accordance with the displayed PARTNER
GSM messages.
6.8 EVENTS bookmark
The NEO real time clock enables writing to the module event memory: input entry violations, functions,
tests etc. The memory can register up to 1000 events taking place recently in such a way, that the oldest
information is overwritten successively.
The following operations can be performed in the bookmark
•
events reading (when communication is active)
•
deleting events from the module memory
•
saving the read list from a disc in .doc format (wordpad) on the computer local disc
The EVENTS bookmark window is split in three columns:
31
