68
Chapter 4 Engraving
4-6 Cutter Installation Method 3 (Diamond Scraper)
Install the solid collet.
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit from
below, then, while holding the spindle unit im-
mobile with a wrench, tighten loosely.
Diameter-4.36 millimeter diamond scrapers can-
not be used with the included solid collet. Provide
a dedicated diamondscraper collet separately.
Fully tighten the solid collet.
Using two wrenches, tighten the solid collet fully.
The appropriate tightening torque is 3.2 N-m
(32kgf-cm) .
2.
Set the lock lever.
Set the lock lever at the or posi-
tion.
For detailed information about the setting posi-
tion for the lock lever, refer to the page indicated
below.
P. 82, “The Position of the Lock Lever”
Wrench
Spindle unit
Solid collet
Wrench
Wrench
Lock lever
Press down to lower
slightly.
Summary of Contents for EGX-350
