Roland EGX-350, User Manual

Page: 105 / 124

103
Chapter 7 Troubleshooting
7-3 Responding to a Message
These are the most common messages that appear
on the machine’s display to prompt correct operation.
They do not indicate any error. Follow the prompts
and take action accordingly.
[Please close the cover]
Close the front cover.
To ensure safety, the machine does not operate when the front
cover is open. However, operations using the movement buttons
on the handy panel are possible while the cover is open.
[Stop performing COVER OPEN]
Close the front cover.
The front cover was opened while the cutter was moving to
a reference point, and so operation of the cutter stopped to
ensure safety.
[Pause On COVER OPEN]
Close the front cover.
This is displayed in the following cases.

Engraving data was sent while the front cover was open.

“VIEW” was selected at the Pause menu, and the cover was opened
during movement to the VIEW position.
Closing the front cover returns the display to the Pause menu.

P. 49 “Pausing and Resuming Cutting”
[Canceling data...]
This is displayed if engraving data is sent during initialization.
After processing to delete the data finishes, the message disap-
pears. When the amount of data is large, it may take some time
for the message to disappear.
[Cannot repeat too big data]
This is displayed when an attempt was made using the Copy
menu to perform engraving again, but the engraving data just
received was too large for the machine’s memory capacity. After
three seconds this message disappears and the screen returns
to the original menu.
[Cannot repeat buffer empty]
This is displayed when an attempt is made using the Copy menu
to perform engraving again while no engraving data is saved in
the machine. After three seconds this message disappears and
the screen returns to the original menu.

P. 78 “Executing Repeated Cutting”
[Turn the AUTO Z CONTROL off]
This was displayed because an attempt was made to set the Z0,
Z1, or Z2 position even though automatic Z control is on.
After three seconds this message disappears and the screen
returns to the original menu.

P. 92 “Origin-setting Menu”