Manual Movement
When the screen on the handy panel displays any one of the messages shown in the figure below, you can move the cutter
manually using the movement buttons.
P. 84, “Menu List”
Each single press of
,
,
,
,
or
performs movement by 0.01 millimeter.
Holding down
,
,
,
,
or
performs slow continuous movement.
Holding down
while pressing and holding
,
,
,
,
or
performs rapid
continuous movement.
Important!
This operation is not possible in the following cases.
When engraving is in progress
When operation is paused
Movement along all axes
(X, Y, and Z)
Movement along only the X
and Y axes
Movement along only the Z axis
(“XXX” is “DOWN,” “SURFACE,”
or “UP.”)
Handy panel
Movement buttons
44
Chapter 3 Basic Operation
3-4 Moving the Cutter
Summary of Contents for EGX-350
