57
Chapter 4 Engraving
4-4 Cutter Installation Method 1 (With Nose Unit)
Install the solid collet.
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit from
below, then, while holding the spindle unit im-
mobile with a wrench, tighten loosely.
Use an appropriate solid collet for the cutter’s
diameter.
Fully tighten the solid collet.
Using two wrenches, tighten the solid collet fully.
The appropriate tightening torque is 3.2 N-m
(32kgf-cm) .
Install the nose unit.
Tighten until no further movement is possible,
then loosen two turns.
P. 61, “Important Notes When Using the Nose Unit”
Wrench
Spindle unit
Solid collet
Wrench
Wrench
Loose
Tighten
Nose unit
Summary of Contents for EGX-350
