RoHS Compliant START-S12-M, Instruction And Warnings For The Installer

Page: 48 / 177

START-S12-M Technical manual
-15-
3.12 Connection of the photo-beam (activated when closing) with TEST
The TEST of the photo-beam works only if the
photo-beams are installed properly. The control
unit will check all connections before opening!
In case the photo-beam are not working pro-
perlym the control unit will lit on for 5 seconds
and the gate is not moving.
To activate the TEST set 1 in the PhOTO-A:
If you go back to function without TEST, do the
connection as in Par.
3.08 and put in 0 the S06
and S09
(deactivate if are inputs are not in test)
S 09
TEST IN PhOTO OUTPUT
1 - Activated
0 - Deactivated
S 06
TEST IN ThE INPUT
SAfETIES
1 - Activated
0 - Deactivated
3.13 Deactivation of the PHOTOCELL A when the gate is closing
S 03
Photocell A deactivated
1 - Activated
0 - Deactivated If you set S03 it deactivates the PhOTO A after in-
tervention of slow down lS. If
S03 is 1
the time of
function T11 is not considered
12 13 14 15 16 17 18 19 20 21 22 23 8 9 10 11
RX
TX
NC Contact
12 Vac
The contact of the receiver should be:
- Isolated (isolated from tensions)
- Normally closed
3.11 Connection of the PHOTO-BEAMS (only when closing)
If the input PHOTO
is not used, set S16 in 0
!
12 13 14 15 16 17 18 19 20 21 22 23 8 9 10 11
RX
TX
NC Contact
12 Vac