RoHS Compliant START-S12-M, Instruction And Warnings For The Installer

Page: 79 / 177

START-S12 Technical manual
-14-
3.8 The connection of PARTIAL OPENING or START
START
Partial
OPENING
The connection of
a START command
can be done with
a button or with a
N.O. contact. When
more devices are
available, connect
them in parallel.
It is possible to connect a timer in the terminal board no. 19 and 21 to program the opening time of the gates.
The contact of the timer should be normally open (N.O.) and it should be closed for all the time the gate is
open. If the conncection of opening command is available in the terminal board no 19, connect it in parallel.
The connection of PARTIAL OPENING
can be done with a button or a normally
open contact.
12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27
TX RX
IRPA 1 / SENSOR-3DD
The terminal boards 28-29-30 are available for the connection of the photo-beams with cable like IRPA 1/
SENSOR-3DD. You can see a standard installation:
-30-
-28-
12Vdc 60mA
PHOTO A when closing
-29-
Output - 12Vdc 60mA
In case the control units is installed in rapid-rise-doors is possible to connect photobeam for unfolding the
curtain. In case the intervention of safeties, the doors stops and reverse the cycle of 1.5sec.
S 17
INPUT UNFOLDING
1 - Activated
0 - Deactivated
The connection of more safety devices can be
done with each button or a N.C. contact. More
safety devices should be connected in serial.
3.9 Connection of the PHOTO-BEAMS with cable (only when closing)
Please read the manual
IRPA1 / SENSOR-3DD
!
3.10 CONNECTION of the safety or UNFOLDING FUNCTION
If the input is not used,
set S17 at 0
!
28 29 30
12 13 14 15 16 17 18 19 20 21 22 23
RX
NC Contact
8 9 10 11
TX
12 Vac