Rohde ELS 1000 S, Original Operating Instructions

Page: 102 / 138

101 / 136 - EN -
WARNING
Risk of serious personal injury or property damage:
⇒ Incorrectly stacked and falling ware can cause injuries or damage to the kiln or
personnel.
⇒ The manufacturer assumes no liability for personal injury or property damage.
Step Description Remark
1 Open the kiln door.
Make sure that the kiln door is always
fully open (opening angle of the kiln door
= at least 90° or greater).
2
Pull the locking brake handle.
Never suddenly release the locking brake
while the kiln floor is being extended and
retracted.
There is a risk that the stacked ware
could fall over!
3 Hold down the handle to move the ELS kiln floor.
The pressed handle releases the locking
brake and allows the floor to move.
4 To stop, let go of the handle.
Letting go of the handle activates the
locking brake and the ELS kiln floor
stops.
5
The ELS kiln floor can be stopped in any position and is fixed
in its position with the locking brake.
6
The so-called Comfort Stop gently applies brakes to the ELS
kiln floor shortly before it reaches the end position.
Comfort Stop consists of 2
hydropneumatic dampers.
⇒ Comfort Stop is set at the factory
and does not need to be
readjusted during operation.
Table 22: Moving the ELS
8.9. Loading the ELS kiln floor
WARNING
Risk of serious personal injury or property damage:
⇒ Incorrectly stacked and falling ware can cause injuries or damage to the kiln or
personnel.
⇒ The manufacturer assumes no liability for personal injury or property damage.
WARNING
Risk of serious personal injury or property damage:
⇒
Never suddenly release the parking brake while moving the ELS kiln floor and never use
the locking brake to stop the floor while it is moving.
⇒
If the locking brake is suddenly released, there is a high risk of goods tipping over or
falling onto the ELS kiln floor.