System Overview
R&S
®
ZVA
81
Quick Start Guide 1145.1090.62 ─ 10
Examples:
●
a
1
Src Port 1 is the outgoing wave at test port 1. In a standard S-parameter mea-
surement, this wave is fed to the input port (port 1) of the DUT (forward measurement).
●
b
1
Src Port 1 is the incoming wave at test port 1. In a standard S-parameter mea-
surement, this is the reflected wave at port 1 of the DUT (forward measurement).
3.3.2.10
Ratios
A ratio measurement provides the complex ratio of any combination of transmitted or
received wave amplitudes. Ratios complement the S-parameter measurements, where
only ratios of the form b
I
/a
j
(ratio of the incoming wave to the outgoing wave at the test
ports I and j of the DUT) are considered.
Examples for using ratios
A measurement of ratios is particularly suitable for the following test scenarios:
●
The test setup or some of its components (e.g. active components or non-reciprocal
devices) do not allow a system error correction so that a complete S-parameter mea-
surement is not possible.
●
The test setup contains frequency-converting components so that the transmitted and
the received waves are at different frequencies.
●
A ratio of two arbitrary waves that is not an element of the S-matrix (e.g. a ratio of the
form a
I
/a
j
) is needed.
The notation for ratios includes the two waves with their directions and test port numbers.
Additionally, the source port must be specified. In analogy to wave quantities, the letter
a indicates an outgoing wave, b an incoming wave.
Examples:
●
b
2
/a
1
Src Port 1 is the ratio of the outgoing wave b
2
at port 2 and the incident wave
a
1
at port 1; this corresponds to the S-parameter S
21
(forward transmission coeffi-
cient).
●
b
1
/a
1
Src Port 1 is the ratio of the wave quantities b
1
and a
1
, measured at PORT 1;
this corresponds to the S-parameter S
11
(input reflection coefficient).
Measured Quantities
