Rockwell Automation ArmorStart Bulletin 280G, User Manual

Page: 133 / 324

Bulletin 284G Programmable Parameters for Sensorless Vector Controllers 4-53
PID Feedback Sel
Valid PID Feedback Sel command for the Bulletin 284G ArmorStart is the following;
2 = Comm Port
Parameter Number 233
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units —
Minimum Value 0
Maximum Value 2
Default Value 0
PID Prop Gain
Sets the value for the PID proportional component when the PID mode is enabled by
Parameter 232 (PID Ref Sel).
Parameter Number 234
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 0.01
Minimum Value 0.00
Maximum Value 99.99
Default Value 0.01
PID Integ Time
Sets the value for the PID integral component when the PID mode is enabled by
Parameter 232 (PID Ref Sel).
Parameter Number 235
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 0.1 sec
Minimum Value 0.0 sec
Maximum Value 999.9 sec
Default Value 0.1 sec
PID Diff Rate
Sets the value for the PID differential component when the PID mode is enabled by
Parameter 232 (PID Rel Sel).
Parameter Number 236
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 0.01 (1/sec)
Minimum Value 0.00 (1/sec)
Maximum Value 99.99 (1/sec)
Default Value 0.01 (1/sec)
PID Setpoint
Provides an internal fixed value for process setpoint when the PID mode is enabled
by Parameter 232 (PID Ref Sel).
Parameter Number 237
Access Rule GET/SET
Data Type UINT
Group Advanced Program Group
Units 0.1%
Minimum Value 0.0%
Maximum Value 10.0%
Default Value 0.0%