Robin RS 1100, User Manual, Page: 86 / 104

【
Start Setup
】
76 【
Exit Setup
】
Set “Check and Send Check digit” the scanner will check according to the last bit, if successful, all the data including
the check digit will be transmitted, the check digit will be treated as the last bit of the normal data; if failed, then the
scanner will indicate “barcode reading failed”
Note: by setting “do not send the check digit”, if the data length except for the 1 character check digit is less than the
minimum barcode reading limit, the barcode reading will be failed. (For example: the scanner set the the minimum
barcode reading leng
th of Plessey to 4 characters and “do not send check digit”, in such circumstances,the scanner is not
able to read the Plessey with 4 characters. )
Set the Barcode Reading Length
The scanner is only able to read the Plessey with tramsmission content length falls in the limited range, the range is
consisted of the maximum value and minimum value in units of character, the Plessey exceeds the range can not be read
or transmitted.
 Read the barcode of “Set the Minimum Length Limit” to adjust the minimum length limit.
 Read the barcode of “Set the Maximum Length Limit” to adjust the maximum length limit.
Set the Minimum Length Limit
Set the Maximum Length Limit
Note
：
the maximum length limit of any 1D barcode must not exceed 255, if the maximum length is shorter than the
minimum length, then the scanner is only able to read the barcodes with the minimum length and the the maximum length;
if the maximum length equals to the minimum length, then the scanner is only able to read the barcode with such length.
MSI-Plessey
Restore the Default Value
By reading the barcode, the parameter setup ofMSI-Plessey will be restored to the factory default state.
No Check
Check and Send Check digit
Check but do not Send Check digit