Switching the transmitter on
Changing the frequency
channel
F X - 4 0
7. SWITCHING THE TRANSMITTER ON / OFF
•
Locate the switch on the transmitter marked “Power”, and slide it
to the right.
•
After the loading and initialisation phase (monitor LED flashes yel-
low) the screen displays the spot frequency confirm field, and the
monitor LED flashes pink.
•
The request to check the spot frequency appears every time you
switch the transmitter on.
•
If the transmitter is set to the correct channel, and you wish to trans-
mit an RF signal, press the “Yes” button.
•
The colour of the monitor LED now changes to a continuous green,
indicating that an RF signal is being broadcast.
•
If you press “No”, the display switches to the Start menu, and no
RF signal is transmitted.
In this case you can now carry out adjustments without radiating
an RF signal, or change the spot frequency, so that the transmitter
starts on the correct channel next time you switch it on.
NOTE:
If the transmitter was last switched on more than four hours previous-
ly, the initialisation phase will take a little longer (cold start). If a D/P card
is fitted this will also prolong the start phase slightly, as the transmitter
must first read all the files on the card.
CAUTION:
Never switch the transmitter off during the initialisation phase
(monitor LED flashes yellow), as this could corrupt the set-
tings.
SWITCHING THE TRANSMITTER OFF
• Move the “Power” switch on the transmitter to the left.
• This action cuts off RF transmission, and causes the data in
the working memory to be written to the transmitter’s inter-
nal memory or the D/P card. During this process the moni-
tor LED flashes yellow, and the screen displays the mes-
sage “Storing model data”.
Switching the transmitter on again during the power-off / data
storing process could also cause damage to data, so the
transmitter ignores your action if you do this.
LANGUAGE SWITCH ENGLISH GERMAN
If your transmitter is set to German screen displays and you
wish to switch to English, please follow this procedure:
• Switch the transmitter on; the query “Transmit?” appears
on the screen
• Press the “No” button
• Call up the System menu by pressing the “S1” button, then
press the “Information” button.
• At bottom left press the “German” button in the Language
field, then select “English”, and switch the transmitter off.
• Switch the transmitter on again, and the screen displays will
now be in English.
20
8. CHANGING THE SPOT FREQUENCY
The system incorporates a DD Synthesizer system which
generates the spot frequencies. The channel is selected at the
transmitter by software, and information on the selected chan-
nel is sent to the receiver using the Wireless Frequency Setting
System (WFSS); the receiver responds by switching to the
same channel.
The new spot frequency is stored in the receiver - even when
it is switched off - until the channel is changed again.
•
Press the Spot frequency field in the Start menu
•
The screen displays the “Frequency” setup menu.
•
Check that the set receiver number (label on the back of
the receiver) is entered correctly, because it is only possi-
ble to transmit a spot frequency if the appropriate receiver
number is transmitted at the same time.
•
Press the Spot frequency button, and the screen displays
a three-page table of channels, showing all the frequencies
approved for use in Europe. Select a channel which is per-
mitted in the country in which you wish to operate the
model. A summary of the frequencies approved for use in
European countries is supplied with the system.
•
Press the “Enter” button to confirm the new spot frequen-
cy you have chosen. (Press “Return” if you wish to inter-
rupt this function without making a change.)
Frequenzkanalwahl
Frequenzbandwahl
Modulationsartwahl
Empfängernummer
Nr. für 2. Empfänger
