RKC INSTRUMENT SBR-EW180, User Manual

Page: 47 / 234

2-3
IMSBR10-E1
Before Using the Recorder
2
Installation Procedure
The recorder should be mounted on a steel panel of thickness 2 mm to 26 mm.
1. Insert the recorder from the front side of the panel.
2. As shown in the figure below, mount the recorder to the panel using the mounting brackets that come
with the package.
• Use two brackets to support the top and bottom or the left and right sides of the case. (Remove the
seal that is covering the holes for the mounting brackets beforehand.)
• The proper torque for tightening the mounting screws is 0.7 to 0.9 Nm.
• Mount the recorder to the panel according to the procedure below.
• First, attach the two mounting brackets and temporarily fasten the attachment screws.
• Next, fix the recorder in place by tightening the attachment screws with the appropriate torque.
When the recorder is approximately perpendicular to the panel as you fasten the screws, press the
mounting bracket against the case so that they are in contact with each other.
(The figure shows the case when the mounting brackets are used on the top and bottom of the case.)
Screw temporarily Fix in place
Front
Panel
Panel
Mounting bracket
Mounting bracket
Torque driver
(flat blade)
Attachment screw
Case
In contact
with each other
Attachment screw
CAUTION
Tightening the screws too much can deform the case or damage the bracket.
2.2 Installation