8. USAGE EXAMPLE
IMR01Y35-E3
70
8.5 PLC Tool Setting
This section explains the procedures for using the programming software STEP7 to configure settings.
8.5.1 Setting procedures
COM-JG initial setting
The procedure for configuring COM-JG initial settings is explained below.
Before configuring COM-JG initial settings, be sure to set DIP switch No. 7 to ON
(controller communication disabled). After you have completed the COM-JG initial
settings, be sure to return DIP switch No. 7 to OFF (controller communication enabled).
(Refer to page 17)
Refer to
8.5.2 General procedures
Creating a new project (P. 73)
Refer to
8.5.2 General procedures
Register a GSD file (P. 76)
Refer to
8.5.2 General procedures
PLC master setting (P. 78)
Refer to
8.5.2 General procedures
Register a COM-JG
(P. 81)
Creating a new project
Register a GSD file
PLC master setting
Register a COM-JG
Starting the Programming
Software STEP7
Data parameter setting
Refer to
8.5.3 COM-JG initial setting
Data parameter setting (P. 83)
Continued on the next page.
Starting the COM-JG
initial setting
Repeat the following procedure (from “Data parameter setting” to “Monitor and
modify of variable”) for each setting item.
[COM-JG initial setting items]
･
Number of continuous accesses
･
Static data read range
･
Continuous accesses enable selection
･
Static data write range
