8. USAGE EXAMPLE
IMR01Y35-E3
104
5.
Set write items in order from “Group 6 ID (base ten).”
The set value sets the Modbus register address of the controller (SRZ) connected in a decimal
number.
In this example, make the setting as follows.
Group 6 ID (base ten): 142: Set value (SV)
[Z-TIO module CH1] *
Group 7 ID (base ten): 109: RUN/STOP transfe
r
[Z-TIO module]
Group 8 ID (base ten): 70: RUN/STOP transfe
r
[Z-DIO module]
*
The number of continuous accesses have been set, and thus it is only necessary to specify CH1.
The factory set value of Group 9 ID (base ten) and following is “65535.”
For Modbus register address of SRZ, refer to
7. COMMUNICATION DATA MAP
(P. 28)
.
6.
After the allocation of data parameters is finished, click “OK.”
Set the following as write items.
142: Set value (SV)
」
[Z-TIO]
109: RUN/STOP transfer
」
[Z-TIO]
70: RUN/STOP transfer
」
[Z-DIO]
