Rizzoli RTE 60, Instructions Manual

Page: 121 / 176

ENGLISH
119
The glasses of the fire door and, in RTVE range
models, of the combustion chamber, can be
cleaned with normal specific products you can find
in commerce. The internal part of the combustion
chamber door is designed to clean itself during the
use of the cooker. Anyway, sometimes you could
have the need to clean also the glass in touch with
the flame of combustion.
Radiating plates in special steel need regular
maintenance, in particular they need cleaning af-
ter every use that brings moisture or dust on the
plate itself. With cold thermal cooker you have to
remove all the pots and boilers that could maintain
moisture on the plate. Together with the thermal
cooker are given some exclusive products, stud-
ied for the cleaning and the maintenance of the
plate: the abrasive sponge, the cleaning oil and the
plate care oil, on how to use them please read the
instructions written on the bottles. The plates are
all worked in with non acid anti-corrosion oil. The
use of the thermal cooker deletes this oil layer and
so the contact with water may cause small rusty
stains. In this case you have to wipe the plate with
a rag soaked with non acid oil. If the rusty stain
is not being cleaned, you could have to wipe the
plate with a lightly abrasive paper or with the abra-
sive sponge given together with the thermal cook-
er. To restore the protecting layer wipe the plate
with little oil. Do not clean the plate with water. It
is important to be sure that the expansion cuts and
the hole between the plate and the frame are not
obstructed by dust or by other residuals: the plate
could suffer deformations, also permanent. When
it is necessary, you should clean also the beating of
the circled removing eventual residuals. Radiating
steel plates, exposed to continuous heating, trend
slowly to take a burnished colour; if you want to
accelerate the process, repeat frequently the oil
wiping. If the thermal cooker is not used for long
periods, it is suggested to treat the plate with the
plate care oil, in this way the plate is well protected
from moisture. To remove the plate, you have to
lift it up. When you reinsert the plate, keep in mind
to leave the 1 or 2 millimetres to allow the thermal
expansion of the plate itself.
5.9 GLASS CLEANING
5.10 PLATE CLEANING AND MAINTENANCE
WARNING! If the chimney cleaning is not made as recommended, fire in the flue could
happen.
WARNING! Do not clean the glass before waiting for its cooling. Suddenly changes in
temperature may cause breakings in the glass.
Oven lamp suffers high temperatures. Even if it
is designed to work in these conditions, it could
become out of order. You have to replace it with
a lamp with the same features (halogen lamp 25W
230V 300° connection G9). To replace the lamp
you have to unscrew the lamp cover, remove the
lamp, insert the new lamp and finally screw in the
lamp cover. Seldom, it is necessary to clean the
glass of the lamp cover. To make this, you have to
unscrew the lamp cover, remove the external re-
siduals due to the cooking steams, wash the lamp
cover and once it is dry you can screw it in its place.
5.11 MAINTENANCE OF THE LIGHT
WARNING! Before starting any maintenance operation for the light, you must disconnect
it from AC power and be sure that the thermal cooker is not powered. Verify also if the
thermal cooker is cold and if the light was turned on in the previous minutes.