Rizzoli RTE 60, Instructions Manual

Page: 95 / 176

ENGLISH
93
Picture 8 – Multiflue thermal cooker with oven, predisposition of the correct flue outlet. In the example, ther-
mal cooker with right flue outlet. The left flue outlet is symmetrical.
RTE 80 - RTE 90 - RTVE 80 - RTVE 90
Picture 9 - Tolerance for flue outlet on the top and back. The tolerance depends on the orientation of the
connector.
+/-
10 mm
Y
X
+/-
10 mm
2.9 CORRECT CONJUNCTION TO THE CHIMNEY
If the conduct of the chimney starts from a low-
er floor than the connection point of the thermal
cooker, it may be necessary to close the conduct
under the connection pipe with fireproof materi-
als. If you have the chimney behind or up, you have
to use the connector with bayonet coupling. This
must be inserted and turned so that it can remain
blocked. This connector has a tolerance of about 1
cm to make the installation easier. The tolerance
is available according to a single direction which
depends on the orientation of the connector (see
picture 9).
If you have a lateral chimney in correspondence
of a side, the connector is sliding. To install it cor-
rectly, it is necessary to remove the cooking plate.
Now, the connector must be completely inserted
inside the wood fired thermal cooker or the chim-
ney, keeping the fixing buttonhole on the same
side of the thermal cooker. Then, you can place
the wood fired thermal cooker, extract correctly
the connector so that it connect the thermal cook-
er with the chimney. Finally, bend the buttonhole
and block the parts with the screw-lock (see pic-
ture 10).