Rizzoli RTE 60, Instructions Manual

Page: 101 / 176

ENGLISH
99
The plinth of the thermal cookers can be regulated
in order to match the space in which the cooker
is inserted. To regulate the pins of the thermal
cooker it is recommended to remove the woodbox
and to place the device laying on the rear side to
have access on the lower part. For this operation
it is suggested to protect the floor with adequate
materials. It is possible to adjust the level of the
cooker by operating on the levelling pins that can
be regulated in height and the recess of the plinth
to the front. To do this, it is necessary to regulate
singularly each pin placed in the plinth near the
corners, so that the adjustment of the cooker is
correct. For the regulation of the pins, use an hex
key n.24 (see picture 18). The pins have an excur-
sion of 20 mm.
To regulate the plinth recess to the front release
the bolts that keep fixed the plinth to the cooker:
the bolts are screwed vertically from the bottom
to the top. Then scroll the plinth in the chosen po-
sition and close the bolts. For this operation it is
necessary an hex key (see picture 19). It is neces-
sary to pay attention to not remove completely the
bolts, release them only for what it is necessary.
2.13 PLINTH REGULATION
Picture 18 – Regulation of the height of the cooker with hex key through the levelling pins.
Picture 19 – Regulation of the plinth recess to the
body of the cooker.
0-20
mm
N. 24
N. 8
0-20
mm
N. 24
N. 8
0-20
mm
N. 24
N. 8