86 | Configuring LAN-Side Internet Breakout on SteelHead SD
Configuring LAN-side internet breakout
Note:
The default route may not be learned from the LAN-side. The traffic is applied to the interface on which the
default route is learned. If a default route is learned from a WAN uplink and the internet breakout preference is
underlay, the traffic would be put on that uplink. If the default route is learned from a LAN-side, the traffic is put on
the LAN interface.
Configuring LAN-side internet breakout
This section describes how to configure LAN-side internet breakout at the organization, site, and zone
level. You can also configure the Underlay option under Traffic Rules.
To configure LAN-side internet breakout at the organization level
1. Choose Organization.
2. Select the Networking Defaults tab.
Figure 9-1. Configuring internet breakout at the organization level
3. Click the search selector and select Underlay.
4. Click
Submit
.
To configure LAN-side internet breakout at the site level
1. Choose Network Design > Sites.
2. Select the site to expand the page.
Summary of Contents for SteelHead 3070-SD
