Configuring AutoVPN on SteelHead SD | 35
Configuring AutoVPN on SteelHead SD
5. Under AutoVPN IPv4 target address, select one of these options:
–
Auto-Detect Internet IPv4 (recommended for internet uplinks)
- The system automatically
detects the external IP that is facing towards the internet. This is the default setting.
–
Internal Interface IPv4 (recommended for private WAN)
- Specify an internal IPv4 IP address.
Use the internal interface address, if it is routed by upstream equipment.
–
Specify custom IPv4
- Specify a custom IPv4 target IP address that remote sites can use when
connecting to this uplink.
6. Click
Submit
.
7. Under Override AutoVPN port, click
On
to enable a different AutoVPN port for this uplink. The port
is used for the source and target ports for this uplink. The default setting is
Off
.
If you have two high-availability (HA) sites that have the same public IP. You must override the
AutoVPN port to ensure tunnels between the two HA sites are established.
8. Specify the port number.
9. Click
Submit
.
Summary of Contents for SteelHead 3070-SD
