INSTALLATION
Installation Instructions for SIS Bus Bar Systems A2MS001EN revision R05
75 / 130
4.7.2
INSTALLING OUTDOOR
CONNECTION SLEEVES
Fill out the check list for outdoor connection sleeves
for each outdoor connection sleeve, see Appendix I
on page 130.
4.7.2.1
PREPARING OUTDOOR
CONNECTION SLEEVES
Introduction
……………………………..... Different ring seal units can be used for outdoor connection
sleeves, depending on the dimensions of the outer stainless
steel protection. However, do not forget that installation must be
performed exactly in accordance with the bill of material and
project specific drawings.
All the dimensions specified in the drawings must be adhered to
prevent insulation damage. Vertical connection sleeves must be
supported by an insulated bracket. If the dimensions from
drawings cannot be adhered, the procedure must be discussed
with RITZ Instrument Transformers GmbH with regard to
possible deviations, before installing the connection sleeves.
Changes must be documented.
4.7.2.1.1
PREPARING THE
BELLOWS
Introduction
…………………………….....
Fig. 72: Tools
If bellows are installed for a bus bar system, they must be
adapted to the respective bus bar diameter. To achieve the
required seal later, you must work precisely and carefully.
A corresponding drawing is included with the delivery of each
bellows.
A sharp knife and protective gloves are required (Fig. 72) to
pre- vent injuries.
