Helvar
| Data is subject to change without notice.
I28 008 1 B
8.5.2019
LC-SRA
Strain Relief Installation Guide
1.
Lock the bottom part to the driver so that it clicks into place.
2.
Connect wires into correct terminals according to driver datasheet instructions.
NOTE for drivers
Ensure that the connector is properly inserted
and pushed firmly into place.
Avoid tension to the connector,
no pushing or pulling force.
Option 1.
Sensor / Control unit cable in the same slot with load cable
Option 2.
Load cable separately in the center slot
(if load cable diameter > 4,8 mm)
Continues on the next page
