RITE-HITE ELIMINATOR II 610 Series, Installation Instructions & Owner'S Manual

Page: 33 / 40

610 SERIES GUTTER ASSEMBLY
GUTTER ASSEMBLY
Pub. 51620004 Rev. 2 - JUNE 2014
I2
2. Once the first tek-screw is in place, again align the
gutter from side to side, parallel to the front bar
bottom edge. (See Figure 2) Starting from center
and going out in each direction, install the the first 2-
3 screws into the holes already in the gutter strip
that land on the marked locations determined in the
curtain face installation instructions. Do not install
screws past the this point. This makes sure that the
gutter does not get misaligned and lays flat. (Note:
Starting from the outside in, can create bulges in
gutter plate.)
3. Once the screws are in place, install the remaining
screws on the outside that land in end cap front flap
area and at the end of the front curtain. Make sure
that a tek-screw lands in the following locations:
- one screw lands at the end of the front curtain
on each side. Approximately 1” off edge.
- one screws lands at last hole on gutter strip to
hold it securely to front bar.
- one screws lands approximately 1” from the
end of end cap front flap to keep it from pulling
down.
4. After all the tek-screws are installed, lay the top
cover front flap with velcro over the newly installed
gutter strip, curtain face and screws. (See Figure 2)
Take care in positioning the flap so it is even along
the front of the unit. Do not pull flap tight over gutter
plate. It should fit correctly slightly loose and the
velcro on flap should just cover and hide the bottom
edge of gutter assembly by approximately 1/2”.
Also, the flap should not be too loose, so adjust its
position as needed.
(Note: Screws go behind canopy flap and are
hidden, they are not to be installed on the
outside of canopy flap).
FIGURE 2