Pub. 28620002 Rev. 4 - JUNE 2014
H2
5.
Install Windstraps - Reference Figure 2.
The first step requires cutting two vertical slits in
the outside edge of the side curtain with a utility
knife. If the slits are already present and at the
correct location as described in Figure 1, this
step can be skipped. Generally, the slits will only
need to be cut during installation if you are
installing a replacement head curtain.
To do this, release the outboard flap of the side
curtain from the side pads in the locations of the
slits. Each slit should be 2" long. The center of
the top slit should be located 3" below the top
edge of the side curtain and 4 1/2" in from back
edge of outboard flap. The lower slit should be
located approximately 6" above the bottom edge
of the head curtain and 4 1/2" in from back edge
of outboard flap.
After the slits are cut, position the top velcro
patch between the outboard flap of the side
curtain and the velcro on the outside of the side
pad. Make sure the patch is oriented such that
the velcro on the side pad and the outboard flap
of the side curtain will latch onto the velcro on the
respective sides of the patch. The D-ring that is
attached to the velcro patch should penetrate
through the slit that was cut near the top of the
side curtain.
The velcro patch with the bungee cord attached
is positioned by the lower slit. It can be installed
by feeding the hook end of the bungee cord
through the slit from the back side of the curtain.
Continue feeding the bungee cord through until
the D-ring on the patch penetrates through the
slit. Again, make sure the patch is oriented such
that the velcro on the side pad and the outboard
flap of the side curtain will latch onto the velcro
on each side of the patch. Press the patch onto
the velcro on the outboard flap of the side curtain
and press the flap back down onto the side pad.
610 SERIES C4-STYLE CURTAIN
C4 STYLE CURTAIN 15 3 OFF GRADE
Cut through side curtain only. Do not cut through
side pad cover.
FIGURE 1
FIGURE 2
NOTICE
Summary of Contents for ELIMINATOR II 610 Series
Page 12: ...610 SERIES SIDE FRAME D5 Pub 56560007 Rev 4 JUNE 2014 FIGURE 5 FIGURE 6 FIGURE 7...
Page 27: ...610 C STYLE CURTAIN OPERATION OF PULL ROPES Pub 28610002 Rev 2 JUNE 2014 G4 FIGURE 5...
Page 38: ...38 Pub ECII 610 Rev 11 September 2015 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
Page 39: ...Pub ECII 610 Rev 11 September 2015 39 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
