RITE-HITE ELIMINATOR II 610 Series, Installation Instructions & Owner'S Manual

Page: 32 / 40

I1
Pub. 51620004 Rev. 2 - JUNE 2014
6 1 0 S E R I E S G U T T E R A S S E M B LY
Table of Contents
File Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . .I1
General Precautions . . . . . . . . . . . . . . . . . . . . . . . . .I1
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .I1
Illustrations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .I1
Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . .I1
Gutter Assembly . . . . . . . . . . . . . . . . . . . . . . . . .I1-2
File Information
Document Name: 51620004
Date Last Revised: 06/30/2014
Revision: 2
General Precautions
Introduction
The following installation instructions are complete
for all applications of the gutter option that are
normally available. Any application of the gutter option
that is outside of normal application guidelines, should
be referred to Order Engineering for installation
instructions. These instructions also assume that the
installer is outside the building facing the loading dock
position.
Illustrations
Illustrations for this document are contained on drawing
#5162-0005
Installation
Gutter Assembly
These instructions illustrate how to install a gutter
assembly on a canopy style header.
(Note: Gutter
goes underneath canopy flap) See Figure 2
1. Before installing any of the screws that attach the
curtain face, install only the center attachment
screw for the curtain face.
(Note: Make sure the
screw is centered on the bar or the gutter may
get mounted to high.)
Do this without the gutter
strip. This screw locates and temporarily holds the
gutter strip in place during it’s installation. (See
Figure 1)
2. Now remove this screw. Locate the gutter strip
center hole over the newly made hole from the tek-
screw and screw in place. (See Figure 1) Before
completely tightening the screw, rotate gutter strip
into approximate parallel position to canopy front
bar bottom edge. Then tighten the screw so it can
hole gutter up, but take care in not stripping the
screw out.
FIGURE 1
WARNING
Post safety warning and
barricade work area, at dock level
and ground level to prevent
unauthorized use of the dock
position while service work is
being performed.