610 SERIES CANOPY STYLE HEADER
Instructions
Common Member
These instructions illustrate how to install a standard
canopy style header, a flat pitch or an integral hood
with a common member side frame and assumes that
the header brackets are installed on side frames.
1. Starting from either side of the common member
side frame, lift the top curtain/bar assembly while
still packaged together and locate across the
already installed side frames. Position it on top so
as the side arms on the top frame are facing the
wall and land between the mounting brackets on
side frames, particularly on side of the common
member. (See Figure 8)
(Note: When installing common member
canopy style headers, it is easier to start from
the common member units and working your
way to the standard units. Start from the center
units (if applicable) and work your way out.
Always verify mounting distances between
header mounting brackets. Too much variances
in mounting distances can cause installation
problems with common member units.)
2. Next, lift the top curtain/bar assembly that
correspond to the other side of the common
member unit. Follow the same procedure as the
first for locating this assembly.
3. Cut the ties to release the backer board free of the
packaged assembly. Once free, slide the backer
board towards the middle of side frame.
4. Starting at the common member side frame, insert
the clevis pin in from one side of the common
mounting bracket through both individual header
side arms and out the other side the bracket. (See
Figure 9) While inserting the pin, install the nylon
spacers between the side arm (not shown) and
middle section of the bracket. One spacer goes on
each side of the middle section. The spacers are
used only on the common member mounting
brackets and are there to keep each header
assembly on the common member side frame
spaced apart from each other. Install the supplied
bridge pin so it cannot slide back out. Do this for
each common member and then for the standard
side frames.
5.
Push the backer boards back towards the mounting
bracket.
FIGURE 7
F5
Pub. 16100003 Rev. 6 - SEPTEMBER 2015
FIGURE 8
Summary of Contents for ELIMINATOR II 610 Series
Page 12: ...610 SERIES SIDE FRAME D5 Pub 56560007 Rev 4 JUNE 2014 FIGURE 5 FIGURE 6 FIGURE 7...
Page 27: ...610 C STYLE CURTAIN OPERATION OF PULL ROPES Pub 28610002 Rev 2 JUNE 2014 G4 FIGURE 5...
Page 38: ...38 Pub ECII 610 Rev 11 September 2015 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
Page 39: ...Pub ECII 610 Rev 11 September 2015 39 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
