610 SERIES CANOPY STYLE HEADER
Pub. 16100003 Rev. 6 - SEPTEMBER 2015
F2
4. Push the backer board back towards the mounting
bracket.
5. At this point, the header mounting brackets can be
drilled or you can wait until after Step 7. To do it
now, make sure the distance between mounting
brackets is correct for the unit to be installed.
(Reference 5656-0007, Figure 3) Drill appropriate
hole for the style of anchor to be used, into the
center of the 1” diameter hole on the header
mounting bracket.
6. Repeat this procedure for the other side.
7. While still on the side you just finished, slide one
end of the installation safety “U” bolt 1/3 the way
into the hole located on the side arm of the top
frame assembly. Lift the front bar assembly until the
“U” bolt aligns with the desired hole on the header
mounting bracket. (See Figure 3) (Note: The correct
hole is when the “U” bolt can be installed and leave
an ample amount of slack in the cover in order to
get backer board into the header mounting bracket.)
Install the “U” bolt all the way through the holes.
Attach the supplied nuts to the “U” bolt threads. For
normal installations, the nuts just can be hand
tightened.
8. Slowly lower the front bar down allowing the “U” to
take up the load.
9. Position yourself under the middle of the header
assembly. Slowly pick up the backer board and
position it behind the tabs on the header mounting
brackets. Insert one side first, then the other. Then
seat both completely. Do not push too hard,
mounting bracket is not mounted to wall yet. The
backer bar should rest on flange part on the
mounting bracket. (See Figure 4)
10. Install a minimum of (5) anchors into the wall that
the header is to be mounted to. (Refer to “Fastening
Methods” section for correct anchors and
attachment methods for the building style the
curtain is being installed on.) If not done already,
two of the (5) anchors need to be mounted on the
ends of the backer board. (See Figure 5) These
holes are pre drilled at the factory for correct
location. These anchors provide load bearing for
the backer board and they also anchor the
mounting brackets to wall.
FIGURE 2
FIGURE 3
WARNING
These two anchors must be installed
through the bracket. Failing to do so,
could cause injury and failure of the
unit to function properly.
WARNING
Do this slow, because the mount-
ing brackets are not anchored.
Dropping the front bar could
cause damage to unit.
Summary of Contents for ELIMINATOR II 610 Series
Page 12: ...610 SERIES SIDE FRAME D5 Pub 56560007 Rev 4 JUNE 2014 FIGURE 5 FIGURE 6 FIGURE 7...
Page 27: ...610 C STYLE CURTAIN OPERATION OF PULL ROPES Pub 28610002 Rev 2 JUNE 2014 G4 FIGURE 5...
Page 38: ...38 Pub ECII 610 Rev 11 September 2015 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
Page 39: ...Pub ECII 610 Rev 11 September 2015 39 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
