610 C-STYLE CURTAIN
WINDSTRAP & PULL ROPE CLEAT INSTALLATION
Pub. 28610002 Rev. 2 - JUNE 2014
G2
5. Lay the canopy top cover front flap with velcro over
the newly installed curtain face and screws. Take
care in positioning the flap so it is even along the
front of the unit. This flap keeps the water from
entering behind the front curtain.
6. Locate pull ropes previously installed at factory.
Attach each pull rope to corresponding loop on
curtain face backside. Make sure knot is secure.
Instructions
Windstraps, “Standard”
These instructions illustrate how to install windstraps
on a standard unit. This does not apply to “Common
Member” installations.
1. Locate the windstrap attachment rings on each front
end edge of the head curtain. (See Figure 2)
2. Feed the hook end of the windstrap through the
fabric pocket on the vertical edge of the curtain, and
attach the hook end of the windstrap to the
attachment rings.
3. Pull the windstrap toward the side member backer
board.
Make sure that the windstrap is
horizontal, not angled up or down.
4. Using the supplied screws attach the eyelet end of
the windstrap to the backer board of the side
member. There should be some slack in the
windstrap after installation. (See Figure 2)
NOTE: - DO NOT ATTACH USING HAMMER &
NAILS. - DO NOT OVER TIGHTEN SCREWS.
EYELET SHOULD SWIVEL FREELY AFTER
INSTALLATION.
Instructions
Windstraps,“Common Member”
These instructions illustrate how to install windstraps
on a “Common Member” c style curtain.
1. Locate the windstrap attachment rings on each front
edge of the head curtain. (See Figure 3)
2. Attach the hook end of the windstrap to the
attachment rings. (See Figure 3)
Instructions
Pull Rope Cleat
1. Position pull rope cleat at a comfortable height on
the left side member backer board.
2. Secure cleat into position using the supplied
screws. (See Figure 4)
3. Anchor pull ropes to the cleat.
Note: Certain applications may make it
necessary to locate the pull rope cleat
elsewhere for accessibility.
FIGURE 1
FIGURE 2
FIGURE 3
Summary of Contents for ELIMINATOR II 610 Series
Page 12: ...610 SERIES SIDE FRAME D5 Pub 56560007 Rev 4 JUNE 2014 FIGURE 5 FIGURE 6 FIGURE 7...
Page 27: ...610 C STYLE CURTAIN OPERATION OF PULL ROPES Pub 28610002 Rev 2 JUNE 2014 G4 FIGURE 5...
Page 38: ...38 Pub ECII 610 Rev 11 September 2015 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
Page 39: ...Pub ECII 610 Rev 11 September 2015 39 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
