E610 SERIES CANOPY STYLE HEADER
Pub. 16100003 Rev. 6 - SEPTEMBER 2015
F4
13. Caulk along the entire edge of the canopy top at the
building wall, making sure the ends are covered.
Use a good grade of flexible caulk.
14. Pull the end caps, located at each end, down to
cover the side frame. Attach the end cap to the side
frame backer using one of screws holding on the
mounting bracket. Attach the velcro on the inside of
the endcap to the velcro on the top flap of side
member.
15. Finally, wrap the end caps front flaps onto the front
bar velcro. (See Figure 6) Align edge on end cap to
top edge of the front bar itself. Do not align to
velcro. Also, do not pull end cap tightly around
corner. Allow the end cap to wrap corner loosely.
This allows the header to flex and proper movement
of side members relative to header during normal
operation. (See Figure 6)
Instructions
Flat Pitch - Over the Sides
The instructions for a flat pitch are the same as for a
standard pitch. The only differences is the header
mounting bracket which is made shorter to achieve the
flat top (Standard flat pitch comes without a gutter)
Instructions
Integral Hood
The instructions for a integral hood are the same as
for a standard pitch, except as noted below. The major
difference is the header mounting bracket which is
made longer to achieve the greater pitch.
1. Before starting Step 5 of the standard canopy style
header installation procedure, install an extra
anchor/fastener through the brackets at the top of
mounting bracket just below the area used for the
backer board. (See Figure 7) With the increased
height of the mounting bracket, extra support is
needed to hold bracket to wall before attaching the
front bar assembly. The front bar assembly imposes
a load on the bracket and with the increased height,
the load is increased. Make sure bracket is in the
correct location before attaching. Verifying bracket
spacing at this time is suggested.
2. Return to Step 5 of standard pitch canopy style
header installation procedure.
FIGURE 6
WARNING
This anchor/fastener is required
for installation. Failing to do so,
could cause injury.
Summary of Contents for ELIMINATOR II 610 Series
Page 12: ...610 SERIES SIDE FRAME D5 Pub 56560007 Rev 4 JUNE 2014 FIGURE 5 FIGURE 6 FIGURE 7...
Page 27: ...610 C STYLE CURTAIN OPERATION OF PULL ROPES Pub 28610002 Rev 2 JUNE 2014 G4 FIGURE 5...
Page 38: ...38 Pub ECII 610 Rev 11 September 2015 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
Page 39: ...Pub ECII 610 Rev 11 September 2015 39 ELIMINATORTM II COMBOSHELTERTM II 610 SERIES NOTES...
