Rigol DG4062, User Manual

Page: 45 / 238

Chapter 1 Quick Start RIGOL
DG4000 User's Guide
1-19
3. Channel Status
Display areas of CH1 and CH2. Indicate whether the corresponding channel is
selected and turned on (ON/OFF).The area of the channel currently selected is
highlighted and the on/off state of the channel currently turned on is "ON".
Note:
When a channel is "Selected", it does not mean that the channel is turned on.
When CH1 is selected, users can configure the parameters of CH1 and the
backlight of
CH1 turns on. When CH1 is turned on, CH1 can output waveform
according to the current configuration and the backlight of
Output1 turns on.
4.
Channel Configurations
Display the current output configuration in each channel, including output
resistance, mode and type of modulating source or trigger source.

Output Resistance
High Impedance: display "HighZ"
Load: display the resistance value, the default is "50Ω"

Mode
Modulation: display "Mod"
Sweep: display "Sweep"
Burst: display "Burst"

Modulating/Trigger Source Type
Internal modulating/trigger: display "Internal"
External modulating/trigger: display "External"
Manual Trigger: display "Manual"
5.
Frequency
Display the current waveform frequency in each channel. Press the
corresponding softkey
Freq and use the numeric keyboard or direction keys
and knob to modify this parameter. The parameter that can be modified
currently will be highlighted and the lightspot above the number indicates
current cursor location.
6.
Amplitude
Display the current waveform amplitude in each channel. Press the
corresponding softkey
Ampl and use the numeric keyboard or direction keys
and knob to modify this parameter. The parameter that can be modified