Rigol DG4062, User Manual

Page: 198 / 238

RIGOL Chapter 10 Utility Functions and System Settings
DG4000 User's Guide
10-28
To Restore the Preset Configuration
Restore the generator to its factory default state or states stored.

Factory Default State: the parameter values are as shown in the table below.
Note that items marked with "*" will not be affected by the preset operation.

States Stored: correspond to the 10 state files stored in the internal memory.
Press
Utility

Preset to select "Default" or one of "User1" to "User10". After
that, pressing
Preset at the front panel under any state will switch the instrument
to the specified state. Note that before selecting any of "User1" to "User10", make
sure that valid state file is stored in the corresponding storage location.
Table 10-1 Factory Default Values
Parameters Defaults
Channel Parameters
Current Carrier
Sine
Output Resistance HighZ
Sync Output On
Sync Polarity Pos
Output Polarity Normal
Noise Superimposition Off
Noise Scale 10%
Coupling Off
Coupling Base CH1
Phase Deviation 0°
Frequency Deviation 0μHz
Amplitude Deviation 0Vpp
Basic Waveform
Frequency
1kHz
Amplitude 5Vpp
Amplitude Unit Vpp
Offset 0V
DC
Start Phase 0°
Square Duty Cycle 50%