Ricoh S-C4.5, Field Service Manual

Page: 362 / 436

No FUNCTION COMMENTS
0-2 Not used Do not change these settings.
3
Printing dedicated tx parameters on
Quick/Speed Dial Lists
0: Disabled
1: Enabled
1: Each Quick/Speed dial number on the list is printed with
the dedicated tx parameters (10 bytes each).
The first 10 bytes of data are the programmed dedicated
tx parameters; 34 bytes of data are printed (the other 24
bytes have no use for service technicians).
4-7 Not used Do not change these settings.
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 [SP No. 1-101-010]
No FUNCTION COMMENTS
0 Not used Do not change these settings.
1
Inclusion of communications on the
Journal when no image data was
exchanged.
0: Disabled 1: Enabled
0: Communications that reached phase C (message tx/rx)
of the T.30 protocol are listed on the Journal.
1: Communications that reached phase A (call setup) of T.
30 protocol are listed on the Journal. This will include
telephone calls.
2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
3
Printing of the error code on the
error report
0: No 1: Yes
1: Error codes are printed on the error reports.
4 Not used Do not change this setting.
5. Appendix: Fax Service Program
166
5