Ricoh A085, Manual

Page: 437 / 617

3. SP MODE PRACTICAL USE TABLE
3.1 REPLACEMENT AND CLEANING
The following table shows the necessary SP modes and the priority order
when the listed items are replaced or cleaned:
No.
SP
Mode
No.
Replaced or
Cleaned
Item
Black
Developer
Color
Developer
OPC Drum
(replace)
ID/V
Sensors
ADS
Sensor
Exposure
Lamp
/Optics
Used
Toner Tank
Description
1. 65
Black Developer
Initialize
O
2. 10
Color Developer
Initialize
O
3. 66 Drum Initialize O
4. 54
Auto Vsg/Vlg
Adjustment
O O
5. 48 Lamp Voltage O (O)
6. 51
Lamp Voltage
Check
O
7. 70
Forced VL
Detection
O
8. 56
Auto ADS Gain
Adjustment
O O O
9. 83
Toner End
Counter Clear
O
NOTE: After replacing the exposure lamp or cleaning the optics, check the
lamp voltage setting [X] by SP48. Then check the target lamp voltage
[Y] decided by the process control through SP51 (press the "." key for
reading). Perform the forced V
L
detection (SP70) [Y- X] times. Check
the target lamp voltage [Z] by SP51. Perform the forced VL detection
(SP70) again. Confirm that the target lamp voltage [Z] is the same
value. If not, repeat the SP70 until the value [Z] does not change.
(Priority Number)
NOTE:
SP MODE PRACTICAL USE TABLE 12 February 1992
4-34