Ricoh A085, Manual

Page: 431 / 617

2.3 SP-8 SENSOR/SWITCH/SIGNAL DATA CHECK
- How to check sensor/switch/signal -
1. While pressing both 1 and 3 on the operation panel number keys, turn on
the main switch in order to access the SP mode.
NOTE: Release the number keys after confirming that the call service
indicator and the copy counter number "0" are blinking.
2. Enter 8 and then press the "#" key.
3. Enter the desired input number using the number keys and press the "#"
key.
NOTE: The input number entered is displayed in the three digit indicator.
4. Enter the number of copies in the copy counter and press the start key if
you want to check the input data during the copy cycle.
NOTE: The on/off status can also be checked manually.
5. The data ("0" or "1") will be displayed in the three digit indicator.
6. To check input data for another sensor, switch, or signal, press the "#"
key twice and repeat from step 3.
Input No. Sensor/Switch/Signal
Data
0 1
1 Registration sensor (S11) Paper not detected Paper detected
2 Fusing exit sensor(S14) Paper not detected Paper detected
4 Upper relay sensor (S10) Paper not detected Paper detected
5 Lower relay sensor (S9) Paper not detected Paper detected
6
Tray relay sensor - 1
(Paper tray unit) (S9)
Paper not detected Paper detected
7
Tray relay sensor - 2
(Paper tray unit) (S10)
Paper not detected Paper detected
8
Tray relay sensor - 3
(Paper tray unit) (S11)
Paper not detected Paper detected
10 Upper tray set sensor (S2) Tray set Tray not set
11 Lower tray set sensor (S3) Tray set Tray not set
12
Tray set sensor - 1
(Paper tray unit) (S1)
Tray set Tray not set
13
Tray set sensor - 2
(Paper tray unit) (S2)
Tray set Tray not set
14
Tray set sensor - 3
(Paper tray unit) (S3)
Tray set Tray not set
16 Upper tray upper limit sensor (S7) Down Up
17 Lower tray upper limit sensor (S8) Down Up
SERVICE PROGRAM MODE 12 February 1992
4-28