Rich electric Invertek CombiPlus, User Manual

Page: 90 / 128

Rich Electric Co. “CombiPlus” User Manual V7.19 Copyright 2009
Page 90
D1-03: Absorption Voltage
Main Menu>Programming>ENT>Charger>ENT
z
Use this setting to specify the absorption battery voltage.
D1-04: Repeated Absorption Time
Main Menu>Programming>ENT>Charger>ENT
z
Use this setting to specify the duration of the repeated absorption “pulses”.
D1-05: Repeated Absorption Interval
Main Menu>Programming>ENT>Charger>ENT
z
Use this setting to specify the interval between repeated absorptions intervals.
D1-06: Maximum Absorption Time
Main Menu>Programming>ENT>Charger>ENT
z
If the Charge Curve is fixed (D1-02=1), then this setting is used to determine the absorption
time.
z
In all other cases, this setting determines the maximum absorption time.
D1-07: Float Voltage
Main Menu>Programming>ENT>Charger>ENT
z
Use this setting to specify the battery float voltage.
D1-08: Charge Current
Main Menu>Programming>ENT>Charger>ENT
z
Use this setting to specify the current with which the battery is charged in the bulk phase.
※
Note: The actual charge current depends on other conditions also. Therefore, under certain
circumstances, it is possible that the actual charge current is lower than this setting. This can,
among others, be due to:
z
A low AC IN Current Limit (B2-05) in combination with a high load.
z
A high environmental temperature
z
A too high ripple voltage due to improper cabling.