Rice Lake SCT-1100, Technical Manual

Page: 47 / 88

Setup Mode 43
 
Setpoint on net weight. Setpoints are set in the same manner as gross weight; See 1 GroS on page 42 . In
addition setpoints can be set and activated on a negative weight
• Positive weight (

set at

)
• Negative weight (

set at

)

Setpoint on the net or gross weight. In this mode setpoints on a negative gross weight can be set.
Accessing the submenu for entering the values of the setpoints differs depending on the functioning
mode selected in the
  
step ( Funct on page 33 ):
• in the

mode press twice in rapid succession
• in the

mode press and hold
NOTE:
This type of output is possible in the

mode with

protocol ( Funct on page 33
),
or in the

mode with the

set to

( CoM. PC on page 52 ).

Setpoint on the number of pieces, in the counting mode only. The setpoints can be set to positive or neg-
ative numbers

Setpoint when the gross weight is at zero

Setpoint when the net weight is at zero

Weight at zero; By selecting this functioning mode, the function of the outputs on the weight (net and
gross) at 0 is enabled
NOTE:
This type of output is possible in the

mode with

protocol
(
Funct on page 33
),
or in the

mode with the

set to

( CoM. PC on page 52 ).

Instability. Function of outputs on an unstable weight is enabled
NOTE: This type of output is possible in the

mode with

protocol
(
Funct on page 33
),
or in the

mode with the

set to

or

( CoM. PC on page 52 ).

Print Key – function of the outputs is enabled when the is pressed

Mode Key – function of the output s is enabled when is pressed

C key – function of the outputs is enabled when is pressed

Zero Key – function of the outputs is enabled when is pressed

Tare Key – function of the outputs is enabled when is pressed

Error indication. Function of the output is enabled on an invalid weight (overload/underload), or without
the signal coming from the cell (disconnected cell)
NOTES:
* In the ind.Ch and

mode the output is enabled only when the condition takes place on
the selected channel.
* In the

mode the output is enabled when the condition takes place on any of the set
channels.
* In a secondary instrument the output is enabled when the repeater is not communicating with
the weighing system; this occurs:
- inside the setup mode of the secondary instrument, or when it displays

- the repeater displays all the central segments in the

mode

Setpoint on the net weight with tare activated; selecting this mode the function of the output on the net
weight is activated if a tare is configured
Parameter Settings Description
Table 4-9. Output Menu
C