Rice Lake SCT-1100, Technical Manual, Page: 37 / 88

Setup Mode 33
4.2.1 Type Parameter
Select the application type: a scale with independent channels, a scale with dependent channels or a scale with
independent channels simultaneously viewable on the PC.
4.2.2 F.Mode Parameters
The function mode parameters set the functionality of the scale.
Table 4-3. F.Mode Menu
Settings Description

Instrument connected to 1, 2, 3 or 4 independent scales.

Instrument connected to a scale with 2, 3, or 4 dependent load cells (could be digitally equalized ).

Independent channel mode which makes it possible to have a transmission, through the serial line, of the values
read by each single channel. See
Section 3.9 on page 18 .
Table 4-2. Type Parameter
Parameter Settings Description

Functioning Mode
NOTE: For the details of the operating modes, see Section 3.10 on page 18 .
Once the functioning mode is selected, if a printer is configured, the printout is automatically enabled.
This parameter is not displayed if trAnSM is set in the tYPE parameter.
MAStr and rEPE are the only parameters displayed in the secondary mode.

Unit of measure conversion

Net weight / gross weight conversion

Input / output weighing
When the in/out mode is selected,

displays momentarily and the setting for the print mode of the
acquired data must be set; Press to confrim selection:

– gross/tare

– first weight/second weigh

– input/output
Table 4-4. Function Mode Parameter
6WG
LQRXW * W 6W QG LQ RXW
K/G
WRW 0RG
0$6WU
QW*6
$OLEL
9L66
3($N
WRWR
WRW6
&RXQ
0D[ WRW
QRU0 W
)$6W W $XWR
WRW 0RG
0D[ WRW
QRU0 W
)$6W W $XWR
X0 $3:
:DLW W
* N* W /E
)XQ&W
&/R&.
6&U 6$9 ‰
U($&W
=(UR
LQ6W
$/:$\6
QR <(6
W$U(
/R&.
XQ/R&.
GL6$E
GL6$E
(Q$E
$XWR))
U(3(
LU &RQ)
LUQR
LU LU
/ LQW
/LQW
/LQW
/LQW
/LQW
/LQW
QX06/
/LVWHQ QR <(6
3URWR& QRU0$/ (;W(QG
W N(\E
NE G*W
NE G)NU NE G):
NE &3:( NE
U6 =(UR
)0RG(
GL6$E
(Q$E