Rice Lake SCT-1100, Technical Manual

Page: 45 / 88

Setup Mode 41
4.3 Output Functions
The instrument is fitted with two opto-isolator photocoupler inputs and two Photo MOSFET outputs. See electric
specifications in Section 2.6 on page 10 .
In the setup  menu ( Figure 4-6 ) t he functioning mode of each of the outputs is set:
• the functioning mode (  )
• none
• setpoint on the gross weight, net weight or pieces
• gross weight at zero or net weight at zero
• weight instability
• totalization
• setpoint on pieces total
• error indication
• Key presses
• the normal status (  ,  ,  )
• the switching condition; direct or with weight stability (  /  )
• active hysteresis; enabling and disabling setpoints or single setpoint (  /  )
• the sign of the configured setpoint (  /  ) for setpoint on net weight and setpoint on pieces
• the output enabling time (  )
• the delay time for enabling the output (  )
Some of functioning modes of the outputs are relative to the specific functioning modes of the instrument; see
the following descriptions for the details.
Figure 4-6. Output Menu
(*) The parameter displays only if the instrument is set as a primary instrument.
(**) The parameter displays only if the instrument is set as a secondary.
If the instrument is in a single range. The w1/sp1 and w2/sp2 LEDs turn on to indicate enabling of the corresponding
output.
Note