REMEHA Quinta Ace, Installation, User And Service Manual

Page: 28 / 80

Tab.10 Shaft dimensions
Type Version Diameter Minimum dimensions of shaft or duct
Without air supply
With air supply
Ø duct □ duct Ø duct □ duct
C
93
Rigid 100 mm 150 mm 150 x 150 mm 150 mm 150 x 150 mm
150 mm 200 mm 200 x 200 mm 220 mm 220 x 220 mm
200 mm 250 mm 250 x 250 mm 280 mm 280 x 280 mm
C
93
Flexible 100 mm 150 mm 150 x 150 mm 150 mm 150 x 150 mm
150 mm 200 mm 200 x 200 mm 220 mm 220 x 220 mm
200 mm 250 mm 250 x 250 mm 280 mm 280 x 280 mm
C
93
Concentric 100/150 mm 200 mm 200 x 200 mm - -
150/220 mm 270 mm 270 x 270 mm - -
6.5.2 Outlets
Flue systems (roof feed-through and outside wall feed-through) must be
supplied by the following manufacturers:
Cox Geelen
Muelink & Grol
Ubbink
Important
Where regulations stipulate that a wire grille must be fitted, use a
suitable grille made from stainless steel.
Boiler-specific roof and outside wall feed-through kits are also available.
Note
Contact us for more information.
6.5.3 Material
Warning
The coupling and connection methods may vary depending on
the manufacturer. It is not permitted to combine pipes, coupling
and connection methods from different manufacturers.
The materials used must comply with the prevailing regulations
and standards.
Tab.11 Flue gas outlet pipework materials
Design
(1)
Material
(2)
Single-wall, rigid Thick-walled, aluminium
Plastic T120
Stainless steel
Flexible Plastic T120
Stainless steel
(1) The sealing must conform to pressure class 1
(2) With CE marking
6 Installation
28 7625116 - v.04 - 17012017