RELM GPH-CMD, Programming Instruction Manual, Page: 51 / 61

RELM Wireless Corporation 47
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

PROG|D/GPH
GROUP 01
The first line shows the type of radio you
want to clone . “D/GPHCMD” is used to
send information when a Command radio is
to be cloned. “D/GPH” is selected to send
information to a non-command radio. Press and hold the [ * ] key to
select the slave radio type.
Long [ # ] keypresses will cyle the second line of the display to show
the data to be coppied to the slave. “Group 00” and “Pick List” are not
valid for non-command radios.
valid data and target selections:
data (line two) valid target (line one)
GROUP 00
(Global data)
D/GPH-CMD only
GROUP 01 - 25 D/GPH-CMD, D/GPH
CMND GRP D/GPH-CMD, D/GPH
PICK LIST D/GPH-CMD only
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

CLONING
Once the data to be transferred has been
selected, press the [FCN] key on the Master
radio keypad. The top line of the display will
flash ‘CLONING’ while the program in the
master is being downloaded to the clone.
If the download was successful, the display on the Master will again
display the clone prompt (target and data to be transferred).
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

FAILURE
If the download was not successful, the
master will flash ‘FAILURE’ and multiple
beeps will follow.
Failure of downloading can be due to:
Improper connection •
Failure to turn on the clone •
Setting the clone in Programming Mode •
Target radio’s group ‘locked’ by PC Programming. •
NOTE: To stop the ‘FAILURE’ Mode, press [CLR], turn off both radios,
and try again, starting with Step 1
When finished cloning, turn off the Clone and disconnect the cloning
cable. Normal radio operation will occur when you turn on the Clone.