RELM GPH-CMD, Programming Instruction Manual, Page: 45 / 61

RELM Wireless Corporation 41
NOTE: To enable User TGID Pick List Selection, press and hold the
‘U’ key “[8] key”. The display will show “UTGID EN”. To disable Pick
List Selection, press and hold the ‘U’ key again. If Pick List Selection is
enabled, but none of the entries has been selected, the radio will use
the default TGID (1) when operating in digital mode.
channel label
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

CHANNEL 2
CHAN LABEL
This field is the channel label for channel 1.
If this label is correct press the [FCN] key to
proceed to the entry point.
If a new channel label is desired, follow the
instructions under “Group Label” in section 2.2.1.2.2.
After the CHAN LABEL is set, the display will return to the Channel
1 starting point. If you wish to review the settings for Channel 1,
subsequent pressing of the [FCN] key will show each value and then
return to the Channel 1 starting point.
At the starting point for Channel 1, the display will show ‘PRG CH 01’.
Press the number keys for another channel number to gain access to
the settings for that channel. Each channel is then programmed using
the same steps described for Channel 1.